The Samraksh Company |
Key Features:
Downlowable Bumblebee device drivers for Imote2 .Net and the TelosB platform are available; see below. BumbleBee radar data can be acquired on the IMote2 by interfacing it to a TelosB with BumbleeBee sensor over the I2C interface.
Our drivers support two data acquisition modes - an on-demand, per-sample acquisition mode or a snippet mode in which the TelosB acquires data continuously and transfers it to the Imote2 when a snippet of a certain length has been collected. We also provide a sample application that demonstrates how to use these drivers in each of these modes to perform robust motion detection on the Imote2 using the BumbleBee radar.
To make the connection to the ITS400 board, cut the cable that ships with the BumbleBee into 2 parts, with the radar end attached to the longer part of the wires. (The radar end of the cable is the one with the black wire connected to pin 1, blue to pin 2 and red to pin 4). You will now need to screw on the free ends of the 3 wires onto the J5 connector, as follows:
You can use any ADC ports on the ITS400; only the port numbers need to be changed in the driver code.
iMote2 Interface Board. | 40.00 USD |